A reserve attestation is a report about a procedure. Firms publish them to show that an outside accountant looked at some set of assets, often cryptoassets at a stated hour, and reported what that look found. Readers then treat the report as proof that customer balances are safe. The report’s own limits are usually printed on it. They are the story.
An audit is an opinion. Many reserve reports are not.
An audit of financial statements, under Public Company Accounting Oversight Board standards or under the AICPA’s auditing standards, is designed to support an opinion on whether those statements are fairly presented. The auditor tests assertions about a whole set of accounts, including what the entity owes, and evaluates whether the evidence is sufficient. The output is an opinion, or a statement that an opinion cannot be given.
A large share of published “proof of reserves” work is narrower. Under the AICPA’s attestation standards, an agreed-upon procedures engagement, AT-C section 215, is one in which the accountant performs specific procedures the engaging party has agreed to, and reports findings. The accountant does not give an opinion or a conclusion on the subject matter. The engaging party, often the crypto firm’s management, agrees that those procedures fit the purpose management had in mind. Users are told to decide for themselves whether the procedures were enough. That is a different product from an audit, even when the same firm’s letterhead is on the page.
What a point-in-time asset check leaves out
The PCAOB’s Office of the Investor Advocate issued an investor advisory on these reports because they are easy to over-read, and because proof-of-reserves work is not subject to PCAOB inspection. The advisory’s substance is concrete. The procedures typically verify an asset type at a moment in time. They generally do not address the entity’s liabilities, the rights of the people the entity calls customers, or whether assets were borrowed so that the snapshot would look complete. They do not show that the same assets were still available the next day. They do not opine on internal control. If management chose the procedures, the report does not contain a representation that those procedures were sufficient.
A cryptographic exhibit does not close those gaps. Signing a message from an address, or including an address in a Merkle tree of customer balances, can show that someone controlled that address at that time and that a particular customer balance was in the list that was hashed. It can be checked. It still does not show that the firm’s debts were included, that the coins were not lent or pledged, or that the customer list was complete. A tree of balances is a commitment to the list someone assembled. Completeness is the question the tree does not answer.
How to read the page that was actually published
Look for the form of the report before looking at the number. Does it say “opinion,” and on which financial statements? Or does it say the accountant performed agreed-upon procedures and lists findings? What hour was the balance observed? Which assets were in scope, and which liabilities, if any, were in scope? Who selected the procedures? A report can be careful, specific, and still silent on solvency. Silence is not a finding that the firm can pay everyone. It is an absence of that finding.
None of this means outside confirmation is useless. A check that addresses you can recompute is better than a screenshot of a dashboard. It becomes misleading only when the caption upgrades a finding about assets at noon into a conclusion about the whole firm. The caption is not the standard. The standard is whichever one the report says the accountant was engaged under, and the procedures are only the procedures written down.
Two lines on the first page usually tell you which standard you are holding. One line names the hour and the assets. The other says whether the accountant expressed an opinion on financial statements or reported findings from procedures management agreed. If the second line is missing, the document is not yet something you can classify. If the first line is a single block height and a list of addresses, you can check those addresses yourself, and you still have not been shown the liabilities. The upgrade from the first fact to “reserves are complete” is the step the report does not take, unless it is an audit opinion that actually says so.




