Gas is Ethereum’s unit for work. A transfer, a contract call, a write to storage, and a deployment each have a gas cost. The protocol charges for that work so that a transaction cannot ask every node to compute forever. Gas is not a token you buy as an investment. It is the meter on a transaction.
The meter and the price
Two numbers get conflated. Gas used is how much work the transaction actually took. The gas price is what the sender pays per unit, in wei. Multiply them and you have the fee in ETH. A complicated contract call can cost more than a plain transfer even when the gas price is the same, because it uses more gas. A plain transfer can become expensive in ETH when the price per gas is high.
The sender also sets a gas limit. If execution tries to use more than the limit, it stops and the state changes from the call are reverted. The fee for the work already metered is still paid. “Out of gas” is not a moral judgment about the contract. It means the limit was below the work the call required.
What EIP-1559 changed
Before the London upgrade, a sender named a single gas price and miners kept the fee. EIP-1559, included in London on 5 August 2021, split the fee. Each block has a base fee that the protocol computes from how full recent blocks were. The sender pays at least that base fee. The sender may also offer a priority fee, a tip, to the block’s proposer. The base fee is burned. The tip is paid to the proposer. Wallets now ask for a max fee and a max priority fee so a user can cap the total.
The base fee rises when blocks run above the target size and falls when they run below it. It is a congestion signal. It is not a vote on the price of ETH, and it is not a guarantee that the next block will be cheap. A wallet’s quote is an estimate of this market, not a protocol promise.
When you read a fee, separate the three parts: how much gas the operation used, what the base fee was, and what tip was offered. Only then convert to ETH. A large ETH fee can be a busy contract, a busy chain, or both.




